Programming Universal Remote Control for Maxell Soundbar

Maxell soundbars produce some of the best surround sound and deep bass at an attractive price. They generally come with remote controls, but if you can’t find it, don’t stress, because you can always use a universal remote. 

In fact, you can learn how to program it with your soundbar in just a few steps. Read on to find out how to do it.

Programming the Universal Remote with a Maxell Soundbar

There are three main ways to set up the universal remote for a Maxell soundbar, which are as follows:

• Code Search Method
• Manual Method
• Keycode Method

Programming with Code Search Method:

If the manual or keycode method doesn’t work for you, you can go for this method:

1. Turn on the device which could be the soundbar.
2. Now select “Setup” and enter the code “991”
3. Then hold the power on/off button and press the Channel up button. Now, wait for the device to turn off.
4. If it turns off, then it means that you have done the procedure correctly.

Now, you can use the remote on your Maxwell soundbar and the devices you wish to control.

The Manual Method of Setting Up the Remote

The manual method is as simple and straightforward as the keycode or code search method. To set the remote by hand, you only have to do two more steps listed earlier in this thread. 

Here’s how you can format your universal remote for the Maxell soundbar without the help of a professional.

1. After switching on the device and the soundbar, the first thing you have to do is check the remote. Make sure it is working correctly on all the devices.
2. If the remote works correctly, select the Setup button and hold it till a small flashlight turns on.
3. The device is in learning mode, so what you have to do is add the keycode in the manual for programming the universal remote.
4. Keep your remote right in front of the device. Select and press the power button, and it will turn off. You can then release the button after.

How to Find Code for the Maxell Soundbar

Finding the code is an easy and straightforward process. All you have to do is the following:

• Find the Program button and then hold it for the time until a small light switches on.
• Now find your soundbar from the soundbar list.
• After selecting the soundbar, enter the codes from the list below and check them properly.
• The small light which was on will now go off. It indicates that you have added the correct code from the list.
• If it does not switch off, you can try adding other codes from the list.

Checking the Universality of Your Remote

Sometimes the remote that comes with your Maxell soundbar is universal. Not only are they compatible with your soundbar, but also with the devices connected to the soundbar as well. To ensure your remote is a universal remote, find the Setup and Mode keys from the remote. If these keys are present, then you are the lucky to have a universal remote

Troubleshooting the Errors on the Remote

Sometimes the remote stops working due to some unknown errors, which are easy to fix if you identify the reason. These are the common reasons behind remote malfunctions:

Batteries

Always check your remote batteries are intact. If they are wet, then you should replace them immediately to avoid further damage [1].

Codes

If you’ve programmed the remote but it’s still not working, you could even try again with a different code. After incorporating the steps above, carefully examine the remote because some of the buttons may work adequately on a code while others do not. By entering the correct code, a remote will perform seamlessly.

Maxell Soundbar Remote Codes

5-Digits Code

• 14516
• 41412
• 42161
• 22165
• 44426

The post Programming Universal Remote Control for Maxell Soundbar appeared first on The Product Analyst.

from The Product Analyst https://theproductanalyst.com/maxell-soundbar-remote-code/